Instal the new for mac Pale Moon 32.2.111/6/2023 ![]() – FT8 decoder: enable averaging of CQ signals with standard callsign in nonstandard DXCall configuration – FT8 decoder: bug fixed, CQ mask shall be used in nonstd mycall configuration – FT8 decoder: reduced Lag, reduced average Lag at QSO – FT8 decoder: better CQ signal recognition in QRM environment – TCI: restore ESDR mode to started mode on closing JTDX, set correct drive value on starting JTDX – TCI: changes to support Thetis HPSDR CAT over TCI ![]() – TCI: code reworked to cope with ESDR band memory – TCI: patch to JTDX configurations Split None and Split Fake It – TCI: better way to handle delay, restore split when changed id esdr to off – TCI: try to decode first incomplete interval after JTDX launching or band change TCI ESDR2 known issues: starting JTDX with ESDR2 have problems in configuration where Split is enabled in ESDR2 and Split Rig option disabled in JTDX, this issue can be fixed in ESDR2 software only JTDX is licensed under the terms of Version3 of the GNU General Public License (GPL) It is created with contributions from DK7UY, DO1IP, ES4RLH,G7OED, MM0HVU, RA4UDC, SV1IYF, UA3ALE, US-E-12, VE3NEA, VK3AMA, VK6KXW, VK7YUM and LY3BG family: Vytas and Rimas Kudelis. © 2016-2017 by Igor Chernikov, UA3DJY and Arvo Järve ES1JA JTDX supports JT9, JT65, T10, FT8 and FT4 © digital modes for HF amateur radio communication, focused on DXing and being shaped by community of DXers. ![]() It is modified WSJT-X software forked from WSJT-X r6462. JTDX means “JT,T10 and FT8 and FT4 modes for DXing”, it is being developed with main focus on the sensitivity and decoding efficiency, both, in overcrowded and half empty HF band conditions.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |